IStorage diskG SSD AES 256-bit 512GB Manuel d'utilisateur télécharger pdf (Page 9)

www.istorage-uk.com

iStorage diskG

SSD Manual – v 2.1

diskG SSD

9. Entering the Admin Mode

To enter the Admin Mode, do the following:

1. Attach the USB cable to an available USB port on your computer. The diskG SSD

goes into the Standby Mode, and the LED indicator light turns RED.

2. Press and hold + 0 for ﬁve seconds until the LED indicator light ﬂashes

RED. This indicates that you can enter the Admin Password.

3. Enter the Admin Password and press . The default Admin Password is

123456. The Secure Solid State Drive is in Admin Mode when the LED indicator light has

changed to BLUE.

Note: If the LED indicator light ﬂashes RED for a few seconds, indicating the diskG SSD has returned to the

Standby Mode, go back to Step 2. This is due to one of the following conditions:

• You entered an incorrect Admin Password in Step 3.

• No activity was detected within two minutes in the Admin Mode.

10. Exiting the Admin Mode

To exit the Admin Mode, press the “Cancel” button in the Admin Mode until the LED indicator light turns RED. This

indicates that you are in the Standby Mode.

Note: The diskG SSD cannot be recognized by the operating system in the Admin

Mode.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Pas de commentaire

IStorage diskG SSD AES 256-bit 512GB Manuel d'utilisateur Page 9