QUICK START GUIDE
Before the drive can be used, the Admin PIN MUST be set.
The LED will display solid BLUE and solid GREEN to indicate the diskAshur PRO SSD
® is waiting for a PIN
to be set.
To Set-up the Admin PIN:
1. Press UNLOCK + 9. The LED will change to solid BLUE and blinking GREEN.
2. Enter the new Admin PIN and press UNLOCK key. If accepted the GREEN LED will flash for 3
short blinks, then return to solid BLUE and blinking GREEN.
3. Re-enter the Admin PIN and press the UNLOCK key. If accepted the GREEN LED will be solid
for 3 seconds.
4. LED will then turn BLUE and remain in Admin mode for 30 seconds or if the LOCK key is
pressed, will return the drive to a standby state.
5. The Admin PIN is now set and will allow access to the drive or the Admin features.
6. To UNLOCK the drive, exit Admin mode by pressing the LOCK button. Then enter the new PIN and
press UNLOCK.
*Note: PINs must be a minimum length of 7 and maximum 16 digits.
Cannot contain all sequential numbers (2345678 or 9876543)
Cannot contain all repeating numbers (1111111)
The SHIFT key can be used for additional combinations.
(e.g. SHIFT+1 is a separate value than just 1)
When you first plug in the diskAshur PRO SSD®,
the unit will do a self-test to verify all security
components are working properly.
The LEDs will go through 3 test stages RED,
GREEN, and BLUE. This will be followed by
three GREEN flashes on a successful test.
Any test failure will leave the diskAshur PRO
SSD
® in an inoperable state with the RED LED
flashing.
First Time Use
3
1
2
SHIFT button
UNLOCK button
LED Indicator lights
4
LOCK button
2
4
3
1
Commentaires sur ces manuels